LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Automatic Transaxle - 4T80-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - On Vehicle >> Automatic Transmission Range Selector Cable Replacement - Console >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Shift Cable & Grommet
    GM294270Courtesy of GENERAL MOTORS CORP.
  1. Install the shift cable through the cowl panel and seat the grommet.
    2. Fig 2: Pulling Lock Release & Remove Transaxle Range Selector Cable From The Console
    GM891290Courtesy of GENERAL MOTORS CORP.
  2. Install the transaxle range selector cable (2) to the console.
  3. Install the lock release (1) to the range selector cable.
  4. Connect the transaxle range selector cable terminal to the shift lever pin.
  5. Install the console trim plate. Refer to Front Floor Console Cup Holder Replacement .
    6. Fig 3: Identifying Manual Shift Lever & Shift Cable
    GM599655Courtesy of GENERAL MOTORS CORP.
  6. Install the transaxle range selector cable (2) into the bracket.
  7. Connect the transaxle range selector cable terminal (1) to the transaxle manual shift lever pin.
  8. Adjust the automatic transmission range selector cable. Refer to Range Selector Lever Cable Adjustment .
scientia non olet · About LEMON Manuals