LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Automatic Transaxle - 4T80-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - Off Vehicle >> Reverse Clutch Housing Installation >> Tools Required

Tools Required

WARNING: This page is about a different variant/trim than selected.

J 34741-3  Input Shaft Seal Sizer

    Fig 1: Installing J 34741-3 Over The Input Shaft Oil Seal Rings
    GM15455Courtesy of GENERAL MOTORS CORP.
  1. Remove the J 34741-3  .
    2. Fig 2: Identifying Reverse Clutch Housing & Second Sprag Assembly
    GM11966Courtesy of GENERAL MOTORS CORP.
  2. Install the reverse clutch housing and the second sprag assembly (500-520) onto the reaction carrier assembly (604). The teeth on the reverse clutch housing must seat into the reaction sun shell. Twist the reverse housing to install and insure proper seating.
  3. Install the thrust washer (436) on top of the reverse clutch housing with the tabs pointing down.
scientia non olet · About LEMON Manuals