LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Automatic Transaxle - 4T80-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - Off Vehicle >> Output Shaft Installation

Output Shaft Installation

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Output Shaft & Snap Rings
    GM15507Courtesy of GENERAL MOTORS CORP.
  1. Inspect the output shaft (57) splines for burrs or damage. Inspect the snap rings (56) for overexpansion.
    2. Fig 2: View Of Snap Rings & Output Shaft
    GM15510Courtesy of GENERAL MOTORS CORP.
  2. Install the snap rings (56) onto the output shaft and install the output shaft (57) from the channel plate side of the transmission.
scientia non olet · About LEMON Manuals