LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Automatic Transaxle - 4T80-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - Off Vehicle >> OSS Sensor and Cooler Fitting Removal

OSS Sensor and Cooler Fitting Removal

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Sensor & Retaining Bolt
    GM11835Courtesy of GENERAL MOTORS CORP.
  1. Remove the 10 mm bolt (131) from the output shaft speed sensor.
  2. Remove the output shaft speed sensor and seal (130).
    3. Fig 2: Cooler Line Fitting & Seal
    GM1592014Courtesy of GENERAL MOTORS CORP.
  3. Remove the 19 mm cooler line fitting (3) and seal (4).
scientia non olet · About LEMON Manuals