Power Steering Pump Installation

WARNING: This page is about a different variant/trim than selected.

Fig 1: Identifying Power Steering Pump Retaining Bolt

Courtesy of GENERAL MOTORS CORP.

Place the power steering pump in position in the engine valley. Slide the molded wedge into the retaining feature cast into the cylinder block.

NOTE: Refer to Fastener Notice in Cautions and Notices.

IMPORTANT: You MUST push the power steering pump toward the rear of the engine as much as possible before tightening the bolt.

Install the power steering pump bolt.
Tighten: Tighten the power steering pump bolt to 50 N.m (37 lb ft).