Tools Required

WARNING: This page is about a different variant/trim than selected.

J 45059 Angle Meter

Fig 1: Identifying Oil Pump Assembly Retaining Bolts

Courtesy of GENERAL MOTORS CORP.

Install the oil pump drive spacer into the oil pump so that the drive flat engages the pump rotor.
Position the oil pump on the crankshaft.
Install the retaining bolts.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Apply upward pressure on the pump while tightening the three retaining bolts. Tighten the bolts in the sequence (1, 2, 3) shown.
1. First Pass
  Tighten: Tighten the oil pump mounting bolts in sequence to 10 N.m (89 lb in).
2. Final Pass
  Tighten: Tighten the oil pump mounting bolts in sequence an additional 35 degrees using the J 45059 .