LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Engine Mechanical - 4.6L (5 Of 5)) >> Off-Vehicle Repair Instructions (3 Of 3) >> Drive Belt Idler Pulley Installation

Drive Belt Idler Pulley Installation

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View of Drive Belt Idler Pulley Bolt
    GM522488Courtesy of GENERAL MOTORS CORP.
  1. Place the drive belt idler pulley and bolt in position.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Tighten the drive belt idler pulley bolt.

    Tighten:  Tighten the drive belt idler pulley bolt to 50 N.m (37 lb ft).

scientia non olet · About LEMON Manuals