Tools Required

J 44212  Camshaft Holding Tool. See Special Tools .

Fig 1: Using Camshaft Holding Tool
Courtesy of GENERAL MOTORS CORP.
1. Remove the J 44212  from the right cylinder head camshafts. See Special Tools .
Fig 2: View Of Camshaft Cover & Bolts
Courtesy of GENERAL MOTORS CORP.
2. Ensure new camshaft cover seals are installed.
3. Place the right camshaft cover in position on the cylinder head by aligning the bolt holes.
NOTE: Refer to Fastener Notice in Cautions and Notices.
4. Install the camshaft cover bolts.

   Tighten:  Tighten the camshaft cover bolts to 10 N.m (89 lb in).

Fig 3: Identifying Ignition Coil Ground Strap & Bolt
Courtesy of GENERAL MOTORS CORP.
5. Install the right ignition coil ground strap to the right cylinder head and right camshaft cover.
6. Install the right cylinder head ignition coil ground strap bolt.

   Tighten:  Tighten the right cylinder head ignition coil ground strap bolt to 25 N.m (18 lb ft).

7. Install the right camshaft cover ignition coil ground strap bolt.

   Tighten:  Tighten the right camshaft cover ignition coil ground strap bolt to 10 N.m (89 lb in).