LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Engine Mechanical - 4.6L (4 Of 5)) >> Off-Vehicle Repair Instructions (2 Of 3) >> Intake Manifold Disassemble

Intake Manifold Disassemble

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Intake Manifold-To-Cylinder Head Gaskets
    GM1012862Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Do not reuse the intake manifold-to-cylinder head sealing gaskets.
  1. Remove and discard the intake manifold-to-cylinder head gaskets.
    2. Fig 2: Identifying Intake Manifold Vacuum Cap
    GM1564158Courtesy of GENERAL MOTORS CORP.
  2. Remove the intake manifold vacuum cap.
    3. Fig 3: Identifying Intake Manifold Plug
    GM1564160Courtesy of GENERAL MOTORS CORP.
  3. Remove the intake manifold plug.
    4. Fig 4: Identifying Intake Manifold Sight Shield Ball Studs
    GM1564164Courtesy of GENERAL MOTORS CORP.
  4. Remove the intake manifold sight shield ball studs.
scientia non olet · About LEMON Manuals