LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Engine Mechanical - 4.6L (4 Of 5)) >> Off-Vehicle Repair Instructions (2 Of 3) >> Camshaft Cover Disassemble

Camshaft Cover Disassemble

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Left Camshaft Cover Gasket & Seals
    GM522722Courtesy of GENERAL MOTORS CORP.
  1. Remove the left camshaft cover gasket and discard.
  2. Remove the left spark plug port seals and discard.
  3. Remove the left ignition module ground/RFI spring port seal and discard.
    4. Fig 2: Identifying Right Camshaft Cover Gasket & Seals
    GM522728Courtesy of GENERAL MOTORS CORP.
  4. Remove the right camshaft cover gasket and discard.
  5. Remove the right spark plug port seals and discard.
  6. Remove the right ignition module ground/RFI spring port seal and discard.
    7. Fig 3: View Of Camshaft Cover Bolts
    GM576614Courtesy of GENERAL MOTORS CORP.
  7. Remove the camshaft cover bolts.
  8. Remove the camshaft cover bolt grommets.
    9. Fig 4: Separating Right Camshaft from Fresh Air Hose Fitting
    GM522719Courtesy of GENERAL MOTORS CORP.
  9. Remove from the right camshaft cover the fresh air hose fitting.
scientia non olet · About LEMON Manuals