LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Mechanical - 4.6L (2 Of 5)) >> On-Vehicle Repair Instructions (1 Of 2) >> Engine Flywheel Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying 8 Engine Flywheel Mounting Bolts
    GM1480384Courtesy of GENERAL MOTORS CORP.
  1. Apply sealant to the flywheel bolts. Refer to Sealers, Adhesives, and Lubricants .
  2. Place the engine flywheel in position against the crankshaft.
    3. NOTE: Refer to Fastener Notice .
  3. Install the flywheel bolts.

    Tighten: 

    • Tighten the bolts a first pass to 30 N.m (22 lb ft).
    • Tighten the bolts a final pass an additional 50 degrees using the J 45059  .

    4. Fig 2: View Of J 44214 & Engine Block
    GM651420Courtesy of GENERAL MOTORS CORP.
  4. Remove the J 44214  from the engine block. See Special Tools .
  5. Install the transaxle. Refer to Transmission Replacement .
scientia non olet · About LEMON Manuals