LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Mechanical - 4.6L (2 Of 5)) >> On-Vehicle Repair Instructions (1 Of 2) >> Drive Belt Replacement >> Removal Procedure 4.6L

Removal Procedure 4.6L

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Drive Belt 4.6L
    GM1660275Courtesy of GENERAL MOTORS CORP.
  1. Remove the right front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement .
  2. Install a 1/2 inch drive breaker to the drive belt tensioner.
  3. Push down on the breaker bar in order to release the tension.
  4. Remove the drive belt from the power steering pump.
  5. Slowly return the tensioner to the original position.
  6. Remove the belt from the lower pulley and idlers.
  7. Partially raise the vehicle. Refer to Lifting and Jacking the Vehicle .
scientia non olet · About LEMON Manuals