Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- Route the drive belt around all the pulleys except for the power steering pump.
- Lower the vehicle.
- Install a 1/2 inch drive breaker bar to the drive belt tensioner.
- Push down on the breaker bar in order to release the tension and route the belt around the power steering pump pulley.
Ensure the belt is seated on all pulleys.
- Slowly return the tensioner to its original position.
- After drive belt installation, inspect the drive belt for the proper routing and correct alignment.
- Install the right front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement .
- Start the engine and check for proper belt and accessory operation.