LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Mechanical - 4.6L (2 Of 5)) >> On-Vehicle Repair Instructions (1 Of 2) >> Camshaft Intermediate Drive Shaft Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Camshaft Intermediate Driveshaft
    GM207544Courtesy of GENERAL MOTORS CORP.
  1. Position the camshaft intermediate drive shaft (1) to the engine, aligning the bolt holes.
    2. NOTE: Refer to Fastener Notice .
  2. Install the camshaft intermediate drive shaft retaining bolts.

    Tighten:  Tighten the camshaft intermediate drive shaft retaining bolts to 15 N.m (11 lb ft).

  3. Install the camshaft intermediate drive shaft sprocket. Refer to Primary Camshaft Drive Chain and Sprockets Replacement .
scientia non olet · About LEMON Manuals