LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls And Fuel - 4.6L - Introduction (2 Of 2)) >> Repair Instructions >> Exhaust Gas Recirculation Pipe Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
IMPORTANT: The exhaust gas recirculation (EGR) valve inlet pipe incorporates a crush seal connection at the water pump housing. The EGR valve inlet pipe must be replaced if disconnected from the water pump housing.
    Fig 1: Identifying EGR Valve Inlet Pipe
    GM1666841Courtesy of GENERAL MOTORS CORP.
  1. Remove the EGR pipe bolt at the water pump housing.
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  3. Loosen the EGR pipe nut at the exhaust manifold.
  4. Remove the EGR valve pipe.
scientia non olet · About LEMON Manuals