LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls And Fuel - 4.6L - Introduction (2 Of 2)) >> Repair Instructions >> Crankshaft Position Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Locating CKP Sensor Wiring Harness Electrical Connector
    GM1672560Courtesy of GENERAL MOTORS CORP.
  1. Lubricate the crankshaft sensor O-ring seal with clean engine oil.
  2. Install the CKP sensor.
    3. NOTE: Refer to Fastener Notice .
  3. Install the CKP sensor bolt.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

    4. Fig 2: Identifying CKP Sensor Wiring Harness Electrical Connector
    GM1672558Courtesy of GENERAL MOTORS CORP.
  4. Connect the CKP sensor wiring harness electrical connector (1) to the CKP sensor.
  5. Install the intake manifold. Refer to Intake Manifold Replacement .
  6. Perform the CKP system variation learn procedure. Refer to Crankshaft Position System Variation Learn .
scientia non olet · About LEMON Manuals