Enabling Procedure
WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the key from the ignition switch.
- Connect both front end sensor connectors (2,5) to each front end sensor (1,4).
- Install both CPA's (3,6) into each front end sensor connector (2,5).
- Install the radiator upper air baffle and deflector.
- Install the SIR Fuse.
- Close the underhood fuse center cover.
- Use caution while reaching in and turn the ignition switch to the ON position.
The AIR BAG indicator will flash then turn OFF.
- Perform the Diagnostic System Check - Vehicle if the AIR BAG warning indicator does not operate as described. Refer to Diagnostic System Check - Vehicle .