LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 97 (HVAC Systems - Manual) >> Diagnostic Information and Procedures >> Re-Calibrating Actuators >> Calibration Procedure

Calibration Procedure

WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.

Use the following steps to perform the calibration update:

  1. Turn OFF the ignition.
  2. Remove the battery positive voltage circuit fuse of the HVAC Control Module.
    3. IMPORTANT: The module memory will not clear if the battery positive voltage circuit fuse is installed in less than 60 seconds.
  3. Wait 60 seconds.
  4. Install the fuse.
scientia non olet · About LEMON Manuals