Installation Procedure
WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
- Install the theft deterrent control module (2)onto the ignition lock cylinder case assembly (1).
- Connect the connector to the theft deterrent control module.
- If necessary, connect the connector to the ignition lock cylinder case.
- Install the lock cylinder. Refer to Ignition Lock Cylinder Replacement .
- Install the upper and lower trim covers. Refer to Steering Column Trim Covers Replacement (Manual Tilt) .
- Enable the inflatable restraint steering wheel module. Refer to SIR Disabling and Enabling Zone 3 in SIR.
CAUTION:
Refer to SIR INFLATOR MODULE COIL CAUTION
in Cautions and Notices.