LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 92 (Steering Wheel & Steering Column) >> Repair Instructions >> Steering Column Trim Covers Replacement (Manual Tilt) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Upper Steering Column Trim Cover & Screw
    GM603845Courtesy of GENERAL MOTORS CORP.
  1. Install the upper steering column trim cover (1) to the closeout shroud.
  2. Install the upper trim cover (1) to the steering column.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the retaining screw (2) to the upper steering column trim cover.

    Tighten:  Tighten the screw to 1.5 N.m (13 lb in).

  4. Install the Ignition lock cylinder.
    5. Fig 2: View Of Lower Steering Column Trim Cover & Screws
    GM603837Courtesy of GENERAL MOTORS CORP.
  5. Install the lower trim cover (2) and ensure that the tabs engage with the tabs on the upper trim cover (1). Snap the tabs together.
  6. Connect the lower steering column trim cover to the closeout shroud.
  7. Install the retaining screws (3) to the lower steering column trim cover.

    Tighten:  Tighten the screws to 3 N.m (27 lb in).

    8. Fig 3: View Of Tilt Lever
    GM603840Courtesy of GENERAL MOTORS CORP.
  8. Install the tilt lever (1).
  9. Install the gap hider. Refer to Instrument Panel Cluster (IPC) Replacement in Instrument Panel, Gages and Console.
  10. Install the knee bolster. Refer to Knee Bolster Replacement - Left in Instrument Panel, Gages and Console.
  11. Install the steering wheel. Refer to Steering Wheel Replacement .
  12. Connect the battery negative cable. Refer to Battery Negative Cable Disconnect/Connect Procedure (L26) or Battery Negative Cable Disconnect/Connect Procedure (LY7) in Engine Electrical.
  13. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in SIR.
scientia non olet · About LEMON Manuals