LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 92 (Steering Wheel & Steering Column) >> Repair Instructions >> Ignition Lock Cylinder Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View of Ignition Cylinder Lock, Ignition Lock Cylinder Case Assembly and Upper Steering Column
    GM375309Courtesy of GENERAL MOTORS CORP.
  1. Install the steering column trim covers. Refer to Steering Column Trim Covers Replacement (Manual Tilt) .
  2. Install the ignition lock cylinder by performing the following procedure:
    1. Align the positioning locking tab slot on the ignition lock cylinder case to the positioning tab on the ignition lock cylinder.
    2. Push the lock cylinder in until the tab locks in the ignition lock cylinder case.
  3. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in SIR.
  4. Connect the battery negative cable. Refer to Battery Negative Cable Disconnect/Connect Procedure (L26) or Battery Negative Cable Disconnect/Connect Procedure (LY7) in Engine Electrical.
  5. Perform the Passlock learn procedure. Refer to Programming Theft Deterrent System Components in Theft Deterrent.
scientia non olet · About LEMON Manuals