Installation Procedure

WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Ignition Lock Cylinder Case Assembly & Screws

Courtesy of GENERAL MOTORS CORP.

Align the ignition lock cylinder case (1) with the steering column tilt head assembly.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Screw the 3 TORX® screws (2) into the ignition lock cylinder case (1).
Tighten: Tighten the 3 TORX® screws to 7 N.m (62 lb in).

Fig 2: Identifying Park Lock Cable At Ignition Lock Cylinder

Courtesy of GENERAL MOTORS CORP.

Press the locking tab on the end of the park lock cable assembly (1) into the slot in the ignition lock cylinder case.

Fig 3: View Of Turn Signal Switch Housing & Steering Column Shaft Assembly

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: Press the turn signal switch housing firmly against the steering column tilt head in order for the screws from the turn signal and multifunction switch assembly to align.

Install the turn signal switch housing. Refer to Turn Signal Switch Housing Replacement
Install the turn signal and multifunction switch assembly only. Refer to Multifunction, Turn Signal Switch Replacement .
Install the steering column tilt head components. Refer to Turn Signal Cancel Cam and Steering Shaft Upper Bearing Spring Replacement .
Install the ignition switch only. Refer to Ignition Switch Replacement .
Install the ignition lock cylinder. Refer to Ignition Lock Cylinder Replacement .
Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in SIR.