LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 91 (Door System, Mirror System & Window System) >> Repair Instructions >> Window Regulator Replacement - Front Door >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Disconnect the power window switch when working inside the driver door. When operated, the Express Up/Down Feature allows the door window to move very quickly, without stopping, which could cause personal injury.
  1. Remove the front door trim panel. Refer to Trim Panel Replacement - Side Front Door .
  2. Remove the front door water deflector. Refer to Water Deflector Replacement - Front Door .
    3. NOTE: Refer to PAINT DAMAGE NOTICE in Cautions and Notices.
  3. Apply masking tape to the outer reveal.
    4. Fig 1: View Of Power Window Motor Electrical Connector
    GM1362843Courtesy of GENERAL MOTORS CORP.
  4. Raise the window far enough in order to gain access through the inner door panel to the window guide retainer clip.
  5. Push inward on the window guide retainer clip locks, lift upward on the window until released from the retaining clip.
  6. Raise the window to the full up position and tape in place.
  7. Disconnect the electrical connector from the power window motor by pulling up on the tab to release it.
    8. Fig 2: View Of Window Regulator
    GM1362845Courtesy of GENERAL MOTORS CORP.
  8. Remove the bolt from the window regulator motor (3).
  9. Remove the nuts (2, 4) from the window regulator studs.
  10. Remove the window regulator and motor through the access opening in the inner door panel.
  11. Remove the power window motor from the window regulator. Refer to Window Regulator Motor Replacement - Front Door .
scientia non olet · About LEMON Manuals