LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 91 (Door System, Mirror System & Window System) >> Repair Instructions >> Window Channel Retainer Replacement - Rear Door >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Rear Door Window Channel Retainer Bolts & Rivets
    GM1363723Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to PAINT DAMAGE NOTICE in Cautions and Notices.
  1. Remove the rear door frame applique. Refer to Door Frame Applique Replacement - Rear .
  2. Remove the rear door trim panel. Refer to Trim Panel Replacement - Side Rear Door .
  3. Remove the rear door water deflector. Refer to Water Deflector Replacement - Rear Door .
  4. Position the window to the full down position.
  5. Remove the rear door inner belt sealing strip. Refer to Sealing Strip Replacement - Rear Door Window Belt Inner .
  6. Remove the rear door outer belt sealing strip. Refer to Sealing Strip Replacement - Rear Door Window Belt Outer .
  7. Remove the rear door window weatherstrip. Refer to Weatherstrip Replacement - Rear Door Window .
  8. Drill out the 4 mm (5/32 in) rivets (1) along the inside edge of the window channel retainer (2).
  9. Remove the bolt (3) from the corner of the window channel retainer (2).
  10. Remove the window channel retainer from the door.
scientia non olet · About LEMON Manuals