Removal Procedure

WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Sealing Strip - Rear Door Window Belt Outer

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to PAINT DAMAGE NOTICE in Cautions and Notices.

Apply masking tape to the door frame and applique.
Remove the rear door trim panel. Refer to Trim Panel Replacement - Side Rear Door .
Lower the window to the full down position.

IMPORTANT: Lift upward on the sealing strip at the front edge of the rear door stationary window to prevent damage to the sealing strip.

Remove the outer belt sealing strip screw.

Fig 2: Releasing Outer Belt Sealing Strip Clip

Courtesy of GENERAL MOTORS CORP.

Release the outer belt sealing strip clip, by inserting a suitable flat-bladed tool to the rear edge and lift upward.
Remove the outer belt sealing strip from the door.