Removal Procedure
WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the rear door trim panel. Refer to Trim Panel Replacement - Side Rear Door .
- Remove the rear door water deflector. Refer to Water Deflector Replacement - Rear Door .
- Open the outside handle rod to lock clip located on the door lock.
The door handle rod should be loose from the lock.
- Remove the screws (1, 3, 2) securing the lock to the door.
- Remove the door lock and cable/rod through the access hole in the door inner panel.
- Disconnect the electrical connector from the lock by pulling out the tab.
- Remove the door lock and cable from the lock.
IMPORTANT:
Do not attempt repairs in order to correct lock discrepancies. Replace the lock.
IMPORTANT:
The outside handles have adjustable outside handle lock rods. This allows for adjustment of the amount of travel needed in order to operate the outside handle.
When servicing a vehicle with adjustable outside handle lock rods, remove all free play between the outside handle and the lock. Also, do not operate the outside handle before these connections are made.
When servicing a vehicle with adjustable outside handle lock rods, remove all free play between the outside handle and the lock. Also, do not operate the outside handle before these connections are made.