LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 90 (Lighting Systems) >> Diagnostic Information and Procedures >> DTC P0573 >> Test Description

Test Description

WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.

The number below refers to the step number on the diagnostic table.

  1. 2:  This step determines if the fault is present.
DTC P0573

Step Action Yes No
Schematic Reference: Exterior Lights Schematics 
Connector End View Reference: Master Electrical Component List in Wiring Systems
1 Did you perform the Diagnostic System Check - Vehicle? Go to Step 2  Go to Diagnostic System Check - Vehicle in Vehicle DTC Information
2 
  1. Connect a scan tool.
  2. Turn ON the ignition, with the engine OFF.
  3. Monitor the stop lamp signal parameter in the cruise control data list while depressing the brake pedal.
Does the stop lamp signal parameter indicate OFF?		 Go to Step 3  Go to Diagnostic Aids
3 Test for a short to ground, an open or a poor connection in the stop lamp voltage supply circuit. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.
Did you find and correct the condition?		 Go to Step 5  Go to Step 4 
4 Replace the body control module (BCM). Refer to Control Module References in Computer/Integrating Systems for replacement, setup and programming.
Did you complete the replacement?		 Go to Step 5  -
5
  1. Use a scan tool in order to clear the DTCs.
  2. Operate the vehicle within the Conditions for Running the DTC as specified in the supporting text.
Does the DTC reset?		 Go to Step 2  System OK
scientia non olet · About LEMON Manuals