LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 8 (Door System, Mirror System & Window System) >> Repair Instructions >> Sealing Strip Replacement - Rear Door Window Belt Outer >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2005 Buick LaCrosse and 2005 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Rear Door Window Belt Outer Sealing Strip
    GM1363714Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Paint Damage Notice in Cautions and Notices.
  1. Apply masking tape to the door frame and applique.
  2. Remove the rear door trim panel. Refer to Trim Panel Replacement - Side Rear Door .
  3. Lower the window to the full down position.
    4. IMPORTANT: Lift upward on the sealing strip at the front edge of the rear door stationary window to prevent damage to the sealing strip.
  4. Remove the outer belt sealing strip screw.
    5. Fig 2: Releasing Outer Belt Sealing Strip Clip
    GM1385553Courtesy of GENERAL MOTORS CORP.
  5. Release the outer belt sealing strip clip, by inserting a suitable flat-bladed tool to the rear edge and lift upward.
  6. Remove the outer belt sealing strip from the door.
scientia non olet · About LEMON Manuals