LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 8 (Door System, Mirror System & Window System) >> Repair Instructions >> Sealing Strip Replacement - Front Door Window Belt Outer >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2005 Buick LaCrosse and 2005 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Front Door Window Belt Outer Sealing Strip
    GM1363661Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Paint Damage Notice in Cautions and Notices.
  1. Apply masking tape to the door and applique.
  2. Lower the window to the full down position.
  3. Remove the outside rearview mirror. Refer to Mirror Replacement - Power .
  4. Remove the outer belt sealing strip screw (2) located at the rear of the door.
    5. Fig 2: Release Front Outer Belt Sealing Strip Retaining Clip
    GM1385553Courtesy of GENERAL MOTORS CORP.
  5. Release the front outer belt sealing strip retaining clip, by inserting a suitable flat-bladed tool to the front edge and lift upward.
  6. Remove the outer belt sealing strip from the door.
scientia non olet · About LEMON Manuals