LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 8 (Door System, Mirror System & Window System) >> Repair Instructions >> Energy Absorber Pad Replacement - Inner Rear >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2005 Buick LaCrosse and 2005 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Energy Absorber Pad
    GM1350776Courtesy of GENERAL MOTORS CORP.
  1. Open the door.
  2. Remove the rear door trim pad. Refer to Trim Panel Replacement - Side Rear Door .
  3. Remove the rear door water deflector. Refer to Water Deflector Replacement - Rear Door .
  4. Remove both push pins from the energy absorber pad (2).
  5. Grasp the energy absorber pad (1) with both hands and pull rearward to release it from the door. If necessary, warm the inner door panel to soften the adhesive.
  6. Remove the inner energy absorber pad from the door.
scientia non olet · About LEMON Manuals