LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 8 (Door System, Mirror System & Window System) >> Repair Instructions >> Door Handle Rod Replacement - Front Outside >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2005 Buick LaCrosse and 2005 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: The outside handles have adjustable outside handle lock rods. This allows for adjustment of the amount of travel needed in order to operate the outside handle.
    When servicing a vehicle with adjustable outside handle lock rods, remove all free play between the outside handle and the lock. Also, do not operate the outside handle before these connections are made.
  1. Remove the front door trim panel. Refer to Trim Panel Replacement - Side Front Door .
  2. Remove the front door water deflector. Refer to Water Deflector Replacement - Front Door .
  3. Raise the window to the full upright position.
  4. NOTE: Refer to Paint Damage Notice in Cautions and Notices.
  5. Apply masking tape around the outside door handle.
  6. Fig 1: View Of Handle Rod To Lock Clip
    GM1350838Courtesy of GENERAL MOTORS CORP.
  7. Open the outside door handle rod to lock clip located on the door lock.

    The outside handle rod should be loose from the lock.

  8. Remove the outside door handle. Refer to Door Handle Replacement - Front Outside .
  9. Fig 2: Outside Handle And Rod
    GM1350846Courtesy of GENERAL MOTORS CORP.
  10. Remove the outside handle (1) and the rod (2) from the door.