LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 78 (Heating, Ventilation And Air Conditioning) >> Repair Instructions >> Heater Pipe Adapter Replacement - Inlet >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2005 Buick LaCrosse and 2005 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Drain the cooling system. Refer to Draining and Filling Cooling System (LY7) or Draining and Filling Cooling System (L26) in Engine Cooling.
  2. Remove the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement in Engine Mechanical - 3.8L.
    3. Fig 1: View Of Heater Inlet Hose At Pipe Adapter
    GM415893Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the heater inlet hose from the pipe adapter.
  4. Use J 38185  in order to position aside the heater hose clamp.
    5. Fig 2: View Of Heater Pipe Adapter
    GM415895Courtesy of GENERAL MOTORS CORP.
  5. Remove the heater pipe adapter mounting bolt.
  6. Remove the heater pipe adapter.
scientia non olet · About LEMON Manuals