LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 53 (Parking Brake System) >> Repair Instructions >> Park Brake Pedal Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Buick LaCrosse and 2005 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Park Brake Pedal Assembly
    GM177091Courtesy of GENERAL MOTORS CORP.
  1. Install the park brake assembly onto the body mounting studs.
  2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the 3 park brake pedal assembly retraining nuts.

    Tighten:  Tighten the nuts to 25 N.m (18 lb ft).

  4. Install the front park brake cable into the bracket on the park brake pedal assembly.
  5. Fig 2: View Of Retaining Clip
    GM648107Courtesy of GENERAL MOTORS CORP.
  6. Insert the cable button into the clevis and install the retaining clip.
  7. Connect the electrical connector to the park brake switch.
  8. Reposition the carpet properly.
  9. Install the left side front carpet retainers and the lower center pillar trim panel on the left side. Refer to Trim Panel Replacement - Lower Center Pillar in Interior Trim.
  10. Install the left side closeout/insulator panel. Refer to Closeout/Insulator Panel Replacement - Left in Instrument Panel, Gages, and Console.
  11. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  12. Install the front park brake cable through the park brake cable guides.
  13. Fig 3: View Of Front Brake Cable Connected To Right Rear Cable
    GM717002Courtesy of GENERAL MOTORS CORP.
  14. Connect the front park brake cable (1) to the rear cable (3) at the connector clip (2).
  15. Fig 4: Adjusting Park Brake Tension At Equalizer Assembly
    GM732929Courtesy of GENERAL MOTORS CORP.
  16. Tighten the nut on the equalizer in order to remove slack in the cable.
  17. Lower the vehicle.
  18. Adjust the park brake system. Refer to Park Brake Adjustment (L26 and L32) .