LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 50 (Seat Belt System) >> Repair Instructions >> Shoulder Belt Guide Adjuster Replacement - Front >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Buick LaCrosse and 2005 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: Verify that the release lever at the top of the bracket is in the full up position.
    Fig 1: View Of Shoulder Belt Guide Adjuster Bracket
    GM157286Courtesy of GENERAL MOTORS CORP.
  1. Position shoulder belt guide adjuster bracket to the center pillar.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the shoulder belt guide belt adjuster bracket bolts.

    Tighten:  Tighten the shoulder belt guide adjuster bracket bolts to 42 N.m (31 lb ft).

  3. Install the upper center pillar trim panel. Refer to Trim Panel Replacement - Upper Center Pillar in Interior Trim.
  4. Install the guide loop to the guide adjuster bracket.
  5. Install the guide loop nut.

    Tighten:  Tighten the guide loop nut to 42 N.m (31 lb ft).

  6. Close the guide loop cover.
scientia non olet · About LEMON Manuals