LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 48 (Engine Cooling System) >> Repair Instructions >> Draining and Filling Cooling System (LY7) >> Tools Required

Tools Required

WARNING: This page is about a different car, the 2005 Buick LaCrosse and 2005 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.

J 26568  Coolant and Battery Fluid Tester. See Special Tools .

CAUTION: To avoid being burned, do not remove the radiator cap or surge tank cap while the engine is hot. The cooling system will release scalding fluid and steam under pressure if radiator cap or surge tank cap is removed while the engine and radiator are still hot.
    IMPORTANT: Draining the cooling system with the pressure cap installed will siphon the coolant from the overflow tank.
  1. Remove the coolant pressure cap.
  2. Place a drain pan under the drain cock.
  3. Open the radiator drain cock.
  4. Drain the cooling system.
  5. If a complete engine block drain is required LY7 engine, remove the coolant drain plugs. Refer to Engine Block Disassemble in Engine Mechanical - 3.6L.
  6. Inspect the coolant.
  7. Follow the appropriate procedure based on the condition of the coolant.
    • Normal in appearance-Follow the filling procedure.
    • Discolored-Follow the flush procedure. Refer to Flushing  .