LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 47 (Hydraulic Brake System) >> Repair Instructions >> Brake Pedal Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Buick LaCrosse and 2005 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Brake Pedal Nut & Bolt
    GM630032Courtesy of GENERAL MOTORS CORP.
  1. Install the brake pedal and bushings.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the brake pedal nut and bolt.

    Tighten:  Tighten the brake pedal nut and bolt to 40 N.m (30 lb ft).

    3. Fig 2: Brake Pedal Pushrod & Washer
    GM179276Courtesy of GENERAL MOTORS CORP.
  3. Install the brake pedal washer and pushrod to the brake pedal.
  4. Install the brake pedal pushrod retaining clip to the brake pedal.
  5. Secure the wiring harness clips to the bracket.
  6. Install the cruise control release switch, if equipped.
  7. Install the stoplamp switch. Refer to Brake Pedal Position Sensor Replacement in Lighting Systems.
  8. Insert the top of the BCM up into the mounting bracket, then engage the bottom of the BCM into the mounting bracket slot.
  9. Install the left instrument panel insulator.
scientia non olet · About LEMON Manuals