LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 45 (Engine Mechanical - 3.6L (Ly7) (Repair Instructions -- 2 Of 5)) >> Repair Instructions (On-Vehicle - Part 2 And Off-Vehicle - Part 1) >> Off-Vehicle Repair Instructions - Part 1 >> Camshaft Position (CMP) Actuator Removal - Right Intake

Camshaft Position (CMP) Actuator Removal - Right Intake

WARNING: This page is about a different car, the 2005 Buick LaCrosse and 2005 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Camshaft Position (CMP) Actuator - Bank1 Intake
    GM946228Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Torque Reaction Against Timing Drive Chain Notice in Cautions and Notices.
  1. Use an open wrench on the hex cast into the camshaft in order to prevent engine rotation when loosening the camshaft position actuator bolt.
  2. Remove the right intake camshaft position actuator bolt.
  3. Remove the right intake camshaft position actuator.
scientia non olet · About LEMON Manuals