Removal Procedure

WARNING: This page is about a different car, the 2005 Buick LaCrosse and 2005 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.

Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.

Fig 1: View Of Prevailing Torque Nut For Outer Tie Rod Assembly

Courtesy of GENERAL MOTORS CORP.

Remove the prevailing torque nut (2) from the outer tie rod assembly (1).

Fig 2: Identifying Tie Rod & Jam Nut

Courtesy of GENERAL MOTORS CORP.

Loosen the jam nut (2) on the inner tie rod assembly (1).

NOTE: Do not attempt to disconnect a steering linkage joint by driving a wedge between the joint and the attached part. Seal damage may result which will cause premature failure of the joint.

Fig 3: Removing Outer Tie Rod Assembly From Steering Knuckle

Courtesy of GENERAL MOTORS CORP.

Remove the outer tie rod assembly from the steering knuckle using J 24319-B .

Fig 4: View Of Outer Tie Rod & Inner Tie Rod

Courtesy of GENERAL MOTORS CORP.

Remove the outer tie rod assembly (3) from the inner tie rod assembly (1).