Installation Procedure

WARNING: This page is about a different car, the 2005 Buick LaCrosse and 2005 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Installing Outer Tie Rod Assembly To Inner Tie Rod Assembly

Courtesy of GENERAL MOTORS CORP.

Install the outer tie rod assembly (3) to the inner tie rod assembly (1). Do NOT tighten the jam nut (2).

Fig 2: View Of Outer Tie Rod & Steering Knuckle

Courtesy of GENERAL MOTORS CORP.

Install the outer tie rod assembly (2) to the steering knuckle (1).

Fig 3: View Of Prevailing Torque Nut For Outer Tie Rod Assembly

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the prevailing torque nut (2) to the outer tie rod assembly (1).
Tighten: Tighten the nut to 46 N.m (34 lb ft).

Fig 4: Installing Outer Tie Rod Assembly To Inner Tie Rod Assembly

Courtesy of GENERAL MOTORS CORP.

Install tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
Lower the vehicle.
Perform a front end alignment. Refer to Measuring Wheel Alignment in Wheel Alignment.