LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 40 (Power Steering System) >> Repair Instructions >> Power Steering Pump Drive Shaft Seal Replacement (CB) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2005 Buick LaCrosse and 2005 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the power steering pump from the vehicle, if necessary. Refer to Power Steering Pump Replacement (3.8L)  or Power Steering Pump Replacement (LY7) .
    2. Fig 1: Power Steering Pump Drive Shaft Seal
    GM1555835Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Protect the drive shaft with the shim stock.
  2. Use a small chisel in order to remove the seal.

    Discard the seal.

scientia non olet · About LEMON Manuals