LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 40 (Power Steering System) >> Repair Instructions >> Power Steering Cooler Pipe/Hose Replacement (L26) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Buick LaCrosse and 2005 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Power Steering Lines And Power Steering Gear
    GM417973Courtesy of GENERAL MOTORS CORP.
  1. Install the cooler pipe/hose to the vehicle.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the cooler pipe/hose to the steering gear.

    Tighten:  Tighten the fitting to 27 N.m (20 lb ft).

  3. Install the wiring harness clip to the cooler pipe/hose.
  4. Install the cooler pipe/hose to the clips on the steering gear.
    5. Fig 2: View Of Cooler Pipe/Hose
    GM284303Courtesy of GENERAL MOTORS CORP.
  5. Install the cooler pipe/hose to the retaining clip on the frame.
  6. Install the cooler pipe/hose retaining bolt to the frame.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

  7. Install the return hose to the cooler pipe/hose. Refer to Power Steering Return Hose Replacement (3.8L) .
  8. Lower the vehicle.
  9. Fill the power steering system. Refer to Checking and Adding Power Steering Fluid .
  10. Bleed the power steering system. Refer to Bleeding the Power Steering System .
  11. Inspect the power steering system for leaks. Refer to Power Steering Fluid Leaks .
scientia non olet · About LEMON Manuals