Engine Front Cover Installation

WARNING: This page is about a different car, the 2005 Buick LaCrosse and 2005 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.

Tools Required: J 45059 Angle Meter

Fig 1: Removing/Installing Engine Front Cover Gasket

Courtesy of GENERAL MOTORS CORP.

Install the engine front cover gasket.

Fig 2: View Of Engine Front Cover

Courtesy of GENERAL MOTORS CORP.

Install the engine front cover.
Align the cogs on the crankshaft sprocket with the cogs on the oil pump in the engine front cover.
Apply sealant GM P/N 12346004 (Canadian P/N 10953480) or the equivalent to the engine front cover bolt threads.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the engine front cover bolts.
Tighten: Tighten the engine front cover bolts to 20 N.m (15 lb ft). Use the J 45059 to tighten the engine front cover bolts an additional 40 degrees.
Install the oil filter.
Tighten: Tighten the oil filter to 30 N.m (22 lb ft).

Fig 3: Removing/Installing Crankshaft Position Sensor

Courtesy of GENERAL MOTORS CORP.

Install the crankshaft position sensor.
Tighten: Tighten the crankshaft position sensor studs to 30 N.m (22 lb ft).

Fig 4: Removing/Installing Crankshaft Position Sensor Shield

Courtesy of GENERAL MOTORS CORP.

Install the crankshaft position sensor shield.