Engine Flywheel Installation

WARNING: This page is about a different car, the 2005 Buick LaCrosse and 2005 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.

Tools Required: J 45059 Angle Meter

Fig 1: Removing/Installing Engine Flywheel Bolts

Courtesy of GENERAL MOTORS CORP.

Install the flywheel.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the new flywheel bolts.
Tighten: Tighten the bolts to 15 N.m (11 lb ft). Use the J 45059 to tighten the bolts an additional 50 degrees.