LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 38 (Engine Mechanical - 3.8L) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Camshaft Removal

Camshaft Removal

WARNING: This page is about a different car, the 2005 Buick LaCrosse and 2005 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing Camshaft Thrust Plat
    GM652337Courtesy of GENERAL MOTORS CORP.
  1. Remove the camshaft thrust plate screws.
  2. Remove the camshaft thrust plate.
    3. Fig 2: Installing Bolt In Camshaft Hole
    GM652340Courtesy of GENERAL MOTORS CORP.
  3. Install one 1/2-20 x 6.0 inch bolt in the camshaft front bolt hole.
    4. Fig 3: Removing Camshaft
    GM652341Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: All camshaft journals are the same diameter, so care must be used in removing the camshaft to avoid damage to the bearings.
  4. Carefully rotate and pull the camshaft out of the bearings.
scientia non olet · About LEMON Manuals