LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 34 (Exterior Trim) >> Repair Instructions >> Molding Replacement - Roof Weld Joint Reveal >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2005 Buick LaCrosse and 2005 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View of Roof Molding
    GM365407Courtesy of GENERAL MOTORS CORP.
  1. Heat the weld join molding, using a heat gun J 25070 152 mm (6 in) from the surface.

    Apply the heat using a circular motion for about 30 seconds.

    2. NOTE: Refer to Exterior Trim Emblem Removal Notice in Cautions and Notices.
  2. To remove the weld joint molding from the roof, begin at one end and use a small plastic flat-bladed tool. Lift the weld joint molding away from the weld joint.
    3. Fig 2: Adhesive Removal Tool
    GM321645Courtesy of GENERAL MOTORS CORP.
  3. Remove all adhesive from the body panel using 3M™ Scotch Brite molding adhesive remover disk 3M™ P/N 07501 or equivalent.
  4. Clean the body panel using Varnish Makers and Painters (VMP) naphtha.
scientia non olet · About LEMON Manuals