LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (Wiring Systems & Electrical Power Management - Introduction) >> Diagnostic Information and Procedures >> Using Fused Jumper Wires

Using Fused Jumper Wires

WARNING: This page is about a different car, the 2005 Buick LaCrosse and 2005 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.

Tools Required: J 36169-A  Fused Jumper Wire. See Special Tools .

IMPORTANT: A fused jumper may not protect solid state components from being damaged.

The J 36169-A  includes small clamp connectors that provide adaptation to most connectors without damage. This fused jumper wire is supplied with a 20-A fuse which may not be suitable for some circuits. Do not use a fuse with a higher rating than the fuse that protects the circuit being tested.

scientia non olet · About LEMON Manuals