LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (Wiring Systems & Electrical Power Management - Introduction) >> Diagnostic Information and Procedures >> Micro-Pack 100W Connectors >> Replacement Procedure

Replacement Procedure

WARNING: This page is about a different car, the 2005 Buick LaCrosse and 2005 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.

After the terminal is crimped to the wire perform the following procedure in order to replace Micro-Pack 100 terminals.

  1. Slide the new terminal into the correct cavity at the back of the connector.
  2. Push the terminal into the connector until it locks into place. The new terminal should be even with the other terminals. Insure that the terminal is locked in place by gently pulling on the wire.
  3. To assemble the connector, reverse the Terminal Removal Procedure.
scientia non olet · About LEMON Manuals