LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 246 (Automatic Transaxle - 4T65-E - Overhaul) >> Repair Instructions >> Wiring Harness Assemble >> Assembly Procedure

Assembly Procedure

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2006 Saturn Relay, 2006 Pontiac Montana SV6, 2006 Pontiac Grand Prix, 2006 Pontiac G6, and 2006 Chevrolet Uplander. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Wiring Harness Assembly
    GM840867Courtesy of GENERAL MOTORS CORP.
  1. Inspect the wiring harness assembly (225) for:
    • Cut or pinched wires
    • Cut wire insulation
    • Bent or broken electrical connectors
    • Damaged terminal pins
    2. Fig 2: Aligning Wire Harness Onto Control Valve Body
    GM840869Courtesy of GENERAL MOTORS CORP.
  2. Position the wire harness assembly (225) onto the control valve body (300) and the pump cover (201).
  3. Mate each connector into its respective electrical component and engage the locking tabs.
  4. Secure the wiring harness conduit into the retaining clip (226) on the pump cover (201).
  5. Assemble the fluid temperature sensor (391) into the temperature sensor clip (390).
scientia non olet · About LEMON Manuals