LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 246 (Automatic Transaxle - 4T65-E - Overhaul) >> Repair Instructions >> Vehicle Speed Sensor Assemble (FWD Only) >> Assembly Procedure

Assembly Procedure

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2006 Saturn Relay, 2006 Pontiac Montana SV6, 2006 Pontiac Grand Prix, 2006 Pontiac G6, and 2006 Chevrolet Uplander. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of VSS & O-Ring
    GM10711Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Handle the vehicle speed sensor assembly carefully.
  1. Inspect the vehicle speed sensor assembly (10) and the vehicle speed sensor O-ring seal (11) for the following conditions:
    • Damaged connector
    • Cracked housing
    • Signs of rotor damage
    • Cuts or nicks on the O-ring seal
  2. Install a new O-ring seal (11) on the vehicle speed sensor assembly (10).
    3. Fig 2: Identifying Vehicle Speed Sensor (VSS)
    GM10516Courtesy of GENERAL MOTORS CORP.
  3. Install the vehicle speed sensor assembly (10) into the case extension.
    4. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  4. Install the vehicle speed sensor bolt (9).

    Tighten:  Tighten the bolt to 12 N.m (106 lb in).

scientia non olet · About LEMON Manuals