Removal Procedure

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2006 Saturn Relay, 2006 Pontiac Montana SV6, 2006 Pontiac Grand Prix, 2006 Pontiac G6, and 2006 Chevrolet Uplander. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Cross Sectional View Of J 41103 Components

Courtesy of GENERAL MOTORS CORP.

Insert the three J 41103-1 puller legs under the Torque Converter Seal (525).
Insert the J 41103-3 support body over the drive sprocket support (522).
Insert the J 41103-2 puller bridge over the J 41103-3 support body. Connect the J 41103-1 puller legs into the slots on the J 41103-2 bridge.

IMPORTANT: The puller legs will damage the torque converter seal (525). Discard the torque converter seal (525) after removal.

Tighten the forcing screw on the J 41103-2 puller bridge until the J 41103-1 puller legs remove the torque converter seal (525).